InFocus IN5106 - Manual (Page 25)

24
Using the audio
To play sound from the projector, connect your source to an Audio In con-
nector on the projector.
To adjust the volume, mute, or loudness, use the Audio menu (see page 31).
Troubleshooting audio
If there is no sound, check the following:
• Make sure the audio cable is connected.
• Make sure mute isn’t active.
• Make sure the volume is turned up enough.
• Make sure you are connected to the corresponding audio in for your
source. By default, Audio 1 corresponds to Computer 2, Audio 2 cor-
responds to Computer 3, Audio 3 corresponds to Video 2 and 3, and
Audio 4
corresponds to Video 1. You can change these assignments,
see page 31.
• Adjust the audio source.
• If playing a video, make sure the playback has not been paused.
Connecting external speakers
The projector can be attached to external speakers that have their own
power source by plugging a speaker cable into the projector’s Audio Out
connector.
connect audio cable
adjust volume
external speakers
speaker
cable