Invacare WALKING TUTOR WT 200 - Manual (Page 4)

Walking Tutor 4 Part No 1141439
FIGURE 3 Attaching the Walking Tutor to the Lift
Assembling the Armrest to Walking Tutor
NOTE: For this procedure, refer to FIGURE 1 on page 2 and FIGURE 4 on page 5.
1. Attach straps to walking tutor arm assembly (FIGURE 1 on page 2).
2. Level the walking tutor arm by using the hand pendant. Refer to Using the Walking
Tutor on page 6.
3. Remove the lever from the walking tutor arm and remove the spacer (not shown).
4. Insert the spacer into the armrest assembly tube.
5. Insert the armrest assembly tube with the spacer inside into the walking tutor arm.
6. Align the hole in the spacer with the walking tutor arm and replace the lever and
tighten in place.
7. Pull out the lever to position it.
DETAIL “A”
DETAIL “C”
DETAIL “B”
DETAIL “D”
Allen Key
Mast
Socket Head Screws
Bearing Block
Pivot
Assembly
Boom Bearing
Retainer
Mast
Socket Head
Screws
Walking Tutor
Bearing Block
Bearing Blocks
Pivot
Assembly
Locknut
Actuator
Walking Tutor
Bearing Blocks