Icom IC-2800H - Manual (Page 79)

75
15
OTHER FUNCTIONS
■ Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing the
memory contents, a partial resetting function is available for
the transceiver.
Band conditions can be reset independently.
D VHF band partial resetting
➥ While pushing the 2nd switch from the top on the left side,
turn power ON to partially reset the transceiver.
• “144M VFO Clear” appears when resetting the VHF band condi-
tion.
D UHF band partial resetting
➥ While pushing the 2nd switch from the top on the right side,
turn power ON to partially reset the transceiver.
• “430M (440M) VFO Clear” appears when resetting the UHF band
condition.
D Partial resetting of both bands
➥ While pushing the 2nd switches from the top on both the
left and right sides, turn power ON to partially reset the
transceiver.
• “VFO Clear” appears when resetting the VHF and UHF band
condition.
■ All reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
• Partial resetting is also available. See previous section for details.
CAUTION: Resetting the transceiver CLEARS all mem-
ory information and initializes all values in the transceiver.
➥ While pushing the 3rd switches from the top on both the left
and right sides, turn power ON to reset the CPU.
• “Memory Clear” appears when resetting the CPU.
[POWER]
All reset
UHF partial
reset VHF partial
reset