Integra DTR-4.6 - Manual (Page 10)

10
Getting to Know the AV Receiver —Continued
A OPTICAL DIGITAL
These optical digital audio inputs are for connecting
components with optical digital audio outputs, such
as CD players and DVD players.
The optical digital audio output is for connecting a
digital recorder with an optical digital input, such as
a CD recorder.
B COAXIAL DIGITAL
These coaxial digital audio inputs are for connect-
ing components with coaxial digital audio outputs,
such as CD players and DVD players.
C REMOTE CONTROL
This (Remote Interactive) jack can be con-
nected to the jack on another -capable Inte-
gra component, for remote and system control.
To use , you must make an analog audio connec-
tion (RCA) between the AV receiver and the other
component, even if they are connected digitally.
D COMPONENT VIDEO IN 1, 2, and 3
These RCA component video inputs are for con-
necting components with component video outputs,
such as DVD players.
E COMPONENT VIDEO OUT
This RCA component video output is for connect-
ing a TV or projector with a component video input.
F XM antenna
This jack is for connecting an XM digital antenna,
sold separately.
G AM ANTENNA
These push terminals are for connecting an AM
antenna.
H MONITOR OUT
The S-Video or composite video jack should be
connected to a video input on your TV or projector.
I FM ANTENNA
This jack is for connecting an FM antenna.
J 12V TRIGGER OUT (A/B/C)
These outputs can be connected to the 12-volt trig-
ger inputs on other components.
K IR IN A/B and OUT
A commercially available IR receiver can be con-
nected to the IR IN A or B jack, allowing you to
control the AV receiver while you’re in Zone 2, or
control it when it’s out of sight, for example,
installed in a cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals along to other components.
L ZONE 2 OUT L/R
The L/R jacks can be connected to a line input on an
amplifier in Zone 2.
M RS232
This port is for connecting the AV receiver to home
automation equipment and external controllers.
N AC INLET
This connector is for connecting the supplied power
cord.
O CD IN
This analog audio input is for connecting a CD
player’s analog audio output.
Rear Panel
3 4 7 5 8 9 J 2 1
U V W
6
O P
K L
Q R
M
S T
N