Integra DV-SP301 - Manual (Page 9)

9
Preparing the Remote Controller
1 Remove the battery compartment cover by pressing
the tab and lifting up the cover.
2 Insert the two batteries (size AAA/R3).
Be sure to match the + and – ends of the batteries with the
diagram inside the battery compartment.
3 Replace the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
Point the remote controller toward the remote control sensor.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of
the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put any object such as a book on the remote controller.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
Inserting the Batteries Using the Remote Controller
Remote control sensor
A
pp
rox
. 1
6
fe
et
(5
m
)
30 °
30 °
00_DV-SP301.book Page 9 Friday, April 18, 2003 4:18 PM