Installing the telescoping tube (figure 2), Adjusting the i.v. rod height (figure 2) – Invacare 1110154 User Manual
Page 3
3
INSTALLING THE TELESCOPING TUBE (FIGURE 2)
NOTE: The support bracket must be mounted to the wheelchair BEFORE installing the telescoping
tube.
1. Insert the telescoping tube into the support bracket.
2. Rotate the telescoping tube until the mounting holes at the bottom align with the mount-
ing holes in the support bracket.
NOTE: The adjustment knob should point towards the outside of the wheelchair.
3. Install the short hex screw and small locknut to secure the telescoping tube to the
support bracket. Torque to 120 in/lbs.
4. Adjust I.V. rod to desired height. Refer to ADJUSTING THE I.V. ROD HEIGHT in this
instruction sheet.
FIGURE 2 INSTALLING THE TELESCOPING TUBE/ADJUSTING THE
I.V. ROD HEIGHT
ADJUSTING THE I.V. ROD HEIGHT (FIGURE 2)
1. Loosen the adjustment knob.
2. Adjust I.V. rod to desired height.
3. Securely tighten adjustment knob.
Telescoping
Tube
Short Hex
Screw
Support
Bracket
Small Locknut
Mounting
Hole
Adjustment
Knob
Telescoping
Tube
NOTE: Rear wheel not shown
for clarity.