Intel IWILL P4D-N - Manual (Page 89)

6: Using The Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 6•3
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Indicator LEDs
The motherboard front panel features connector supports
three system status indicator LEDs:
• Power Status LED Indicator
Lights when the system is turned on.
• Hard Disk Drive Activity LED Indicator
Flashes during hard disk drive access.
• Power Conservation Mode LED Indicator
Lights to indicate the system is in a Suspend state
power conservation mode.
Most system housings will have all of these LEDs mounted
in the housing’s front panel.
Additional System Features
This motherboard supports a system “Wake Up” feature
that allows the system to resume from a Suspend state in
response to a hardware event.
Wake-on LAN (WOL)
Function: The system wakes up in response to a signal
arriving over a LAN that it is connected to.
Use: The P4D-N’s onboard LAN interface supports the
WOL feature. In addition, the onboard WOL connector
supports connection to an additional PCI Network Inter-
face Card. The WOL cable from the card connects to the
WOL connector on the board.
The feature is not enabled by default in the Power Man-
agement section of the CMOS Setup Utility. If you want
to use it, set the “Wake-Up by PCI card” line to Enabled.