Ikelite SD630 - Manual (Page 4)

8
D Diiffffuusseerr & & D Deefflleeccttoorr IInnssttaallllaattiioonn
Housing shown with
Diffuser installed
Diffuser
U Ussiinngg FFllaasshh
U
Ussiinngg tthhee CCaam meerraa’’ss BBuuiilltt iinn FFllaasshh
If you do not have an external flash the camera’s built in flash
can be used See Diffuser instructions
9
D Diiffffuusseerr aanndd D Deefflleeccttoorr ccoonntt
A diffuser and deflector are
included with the housing The
diffuser is white transparent
plastic The deflector is also
white but is not transparent
and has a decal on the front
To install the diffuser or
deflector spread the port clamp
at the spring end and slide over
the lens port The white plastic
should be placed in front of the
camera flash The port clamp
should be pushed back against
the front of the housing
D Diiffffuusseerr
The diffuser should be installed when using the camera’s built in
flash When shooting with the camera’s built in flash at
approximately feet ( m) or less the lens port on the
housing may block a portion of the light from the camera’s
built in flash creating a shadow in the lower left of the photo
If this occurs zoom the lens slightly to eliminate the shadow
(You can test this above water)
D Deefflleeccttoorr
The deflector should be installed when using an external strobe
such as the DS or DS Substrobe and EV Controller The
deflector will redirect the camera’s flash to the EV Controller
which controls the external strobes output
Diffuser/Deflector material
Port Clamp
Spring
Spread to Install
LLeennss PPoorrtt
Treat the glass in the lens port as a camera lens After use rinse
and gently dry the lens port to avoid water spotting To clean
use a mild soap solution or lens cleaner
Do not use alcohol or window cleaner on the Lens Port
The Lens Port will accept ( ) Wide Angle Adapters The Wide
Angle Adapter which is required to mount the Inon
UWL AD Bayonet style wide angle lens The Wide Angle
Adapter is required to mount the following Wide Angle
Lenses Inon UWL Sea&Sea and Ep que DCL
screw thread ( mm) style wide angle lenses
These lenses can be secured onto the Wide Angle Adapter
above or below water as they are designed to have water
between the front of the port and the accessory lens Make sure
no air bubbles are trapped between the port and the accessory
lens Any vignetting that occurs can be eliminated by zooming
the camera lens slightly The camera’s built in flash cannot be
used with wide angle
lenses The front of the
lenses are so large they
block the camera’s flash
To properly light subjects
when using a wide angle
lens an external strobe
should be used Due to
the wide angle of
coverage of these lenses
the DS Substrobe is
recommended or two
DS Substrobes
10 11
O Oppttiioonnaall AAcccceessssoorriieess
BBaacckk O
O’’rriinngg
O’rings last for several years if properly maintained (See
maintenance) Always carry a spare
W Wiiddee AAnnggllee AAddaapptteerr
Required to mount Inon UWL AD Bayonet style wide angle
lens
W Wiiddee AAnnggllee AAddaapptteerr
Required to mount Inon UWL Screw Thread ( mm) style
wide angle lens
U URR//PPrroo FFiilltteerr
The UR/Pro underwater color correcting filter is designed to
restore some of the warm colors filtered out by the water For
available light use only not recommended for use with flash
TTrraayy w wiitthh RReelleeaassee H Haannddllee
Tray and Release Handle is required to mount external
Substrobes
wide-angle lens
Wide-Angle Adapter