Setting the aspect ratio of your tv, Troubleshooting – Insignia NS-LCD42 User Manual

Page 19

Advertising
background image

17

Insignia NS-LCD42 42" LCD TV

www.insignia-products.com

Setting the aspect ratio of your TV

To set the aspect ratio of your TV:

1 Turn on your TV.

2 Press the ZOOM button on the remote

control to select from the following settings:

•

ZOOM–Stretches the image vertically and
horizontally to keep the image size
consistent in the center of the screen,
while it stretches the sides.

•

CINEMA–Stretches the image vertically
and horizontally to fill the screen on
widescreen programs with an aspect ratio
of 1:2:35.

•

WIDE–Stretches the image vertically and
horizontally to fill the screen on
widescreen programs with an aspect ratio
of 1:1:85 (the typical widescreen setting).

•

NORMAL–Recommended for viewing
standard 4:3 aspect ratio programming
(black bars appear on the sides of the
display).

Troubleshooting

Check this table for a possible solution to your
problem before contacting a customer service
representative.

Note

This television is equipped with a safety fuse
located behind a plastic cover adjacent to the AC
plug on the rear panel. This fuse is designed to
protect the TV in the event of a power surge.
If the TV has no power, unplug the AC power cord,
then check for a blown fuse by prying open the
plastic cover. If the fuse is blown, replace with a
4A 250 slowblow fuse (5x20mm).

Symptom

Possible solutions

Cannot receive certain
channels through the
antenna

• Use the automatic channel

scanning function to add the
channels not present in memory.
See “Performing the initial setup”
on page 11.

• The signal from the TV station

may be weak.

No color

• Check the video portion of your

external A/V equipment.

• Adjust the antenna for better

reception.

Video noise or choppy
picture

• Adjust the antenna for better

reception.

• Keep the TV away from noise

sources such as neon lights and
microwave appliances.

Some TV channels
blocked

• Use the automatic channel

scanning function to add the
channels not present in memory.
See “Performing the initial setup”
on page 11.

• Check parental control settings.

See “Setting up Parental
Controls
” on page 14.

Overlapping or ghost
images

• Use a directional rooftop antenna

or cable/satellite service.

Cannot use certain
functions

• If the function chosen is grayed

out, that item cannot be selected
in the current mode. Switch
modes and try again.

No sound

• Make sure that audio cables are

fully connected.

• Make sure that you have selected

the correct audio source from
your amplifier.

• Make sure that the Mute function

is not enabled (press MUTE on
the remote).

Black box on the screen

• The Text option is enabled and no

text is available. Turn of closed
captions in the Setup menu (see
“Setting up Closed Captioning”
on page 14)

No power

• The batteries in the remote

control may need to be replaced.

• Reconnect the AC plug to a wall

outlet.

• Check the safety fuse on the rear

panel (see Note above).

No picture

• The digital TV channel signal may

be weak. Try another channel.

• Press the INPUT button

repeatedly to select connected
A/V equipment.

• Reconnect the antenna or cable

wiring.

Advertising