Insignia NS-AV511 - Manual (Page 29)

25
Insignia NS-AV511 Surround Sound Receiver
www.insigniaproducts.com
Selecting a digital input signal format (Fixed
Mode)
The digital input signal formats are available only
for the input sources that you have assigned a
digital input jack.
Normally, the receiver detects the signal format
automatically. However, if you experience any
issues when playing PCM or DTS material, you can
manually set the signal format to PCM or DTS.
• Off–The format is detected automatically. If no
digital input signal is present, the
corresponding analog input is used instead.
• PCM–Only 2-channel PCM format input
signals are heard. If the input signal is not
PCM, the PCM indicator flashes and noise may
also be produced.
• DTS–Only DTS (but not DTS-HD) format input
signals is heard. If the input signal is not DTS,
the DTS indicator flashes and there is no
sound.
OSD Setting
Volume OSD
• On
• Off
Select On when you want to display the volume
level on-screen when it is adjusted.
Auto Standby
Auto Standby
• On
• Off
When Auto Standby is set to On, the Surround
Sound Receiver automatically returns to Standby
when no audio or video signal is received for 30
minutes.
Controlling other
components
You can use your receiver’s remote control to
control your other AV components. This section
explains how to enter the remote control code for a
component that you want to control, such as a DVD
player, a TV, or a CD player. See “Remote control
codes” on page 26.
Preprogrammed remote control codes
Remote control codes for Insignia Blu-ray disc
players and Insignia TVs are preprogrammed into
the remote control. You do not need to enter a
remote control code to control these components.
To enter remote control codes:
1 While holding down the REMOTE MODE button
to which you want to enter a code, press and
hold down the DISPLAY button until the
Remote indicator lights up (about three
seconds).
2 Within 30 seconds, press the number buttons to
enter the 5-digit remote control code. The
Remote indicator flashes twice.
To reset a REMOTE MODE button:
1 While holding down the REMOTE MODE button
that you want to reset, press and hold HOME
until the Remote indicator lights (about three
seconds).
2 Within 30 seconds, press the REMOTE MODE
button again.
The Remote indicator flashes twice, indicating
that the button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is
reset, its preprogrammed code is restored.
To reset the remote control:
1 While holding down the RECEIVER button,
press and hold HOME until the Remote
indicator lights (about three seconds).
2 Within 30 seconds, press the RECEIVER button
again.
3 The Remote indicator blinks twice, indicating
that the remote control has been reset.
To control other components:
• Press the REMOTE MODE button that you have
programmed with the remote control code for
your component.
Notes
• If the beginnings of tracks from a PCM source
are cut off, try setting the format to PCM.
• If noise is produced when fast forwarding or
reversing a DTS CD, try setting the format to
DTS.
• The setting is stored individually for each input
selector.
• The setting is reset to Off when you change the
setting in the Audio Selector.
Note
The Auto Standby function may activate during
playback of some source.
NS-AV511_11-0201_MAN_.book Page 25 Wednesday, April 13, 2011 9:31 AM