Ives Offset Top Pivot 7244F - Manual (Page 2)

26488 Rev. 3
26488-00
Right hand installation shown;
left hand opposite
It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below.
NOTE !
1-1/16
27 mm
Edge of base
plate is flush
with edge of
door
1-1/8”
29 mm 3/4”
19 mm
2-3/8”
60 mm
Depth of mortise will
vary depending upon
installation and/or
threshold height. *
* 1-1/16”
27 mm
to
5/8”
16 mm *