Impex PWR 6 User Manual
Powerhouse club, Pwr 6, Model pwr 6
Advertising
Table of contents
Document Outline
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 3
- ASSEMBLY INSTRUCTIONS........................................................................... 5
- EXPLODED DIAGRAM.........................................................................………. 17
- PARTS LIST………………………………………………………………………….. 19
- WARRANTY.................................................................................................… 20
- ORDERING PARTS......................................................................................... 20
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Attach an Upright Beam (#49) to a Floor Stabilizer (#47). Secure it with two M10 x 2 3/4” Carriage Bolts (#81), ( ¾” Washers (#42), and M10 Aircraft Nuts (#44). Do not tighten the nuts and bolts yet.
- Attach the upper end of Left Support (#50) to the Upright Beam. Secure it with one M10 x 5/8” Allen Bolt (#88) and ( ¾” Washer (#42).
- Attach the lower end of Left Support (#50) to the Floor Stabilizer (#47). Attach one end of the Rear Stabilizer (#53) to the Floor Stabilizer. Align the holes and secure them with two M10 x 3 ¾” Carriage Bolts (#83), ( ¾” Washers (#42) and M10 Aircraft N
- Repeat Steps A, B and C above to install the other side.
- Securely tighten all Nuts and Bolts.
- DIAGRAM 6
- PARTS LIST
- KEY NO. DESCRIPTION Q’ty