Parallel port connector (cn14), Parallel port irq, Parallel port connector table (cn14) – IBM All-in-One Super7 Single Board Computer PCM-5896 User Manual
Page 47
Chapter 2 Installation 35
Parallel port connector (CN14)
Normally, the parallel port is used to connect the board to a
printer. The mainboard includes an onboard parallel port, accessed
through CN14, a 26-pin flat-cable connector. You need an adapter
cable if you use a traditional DB-25 connector. The cable has a
26-pin connector on one end and a DB-25 connector on the other.
Parallel port IRQ
The mainbaord supports one parallel port. The port is designated
as LPT1 and can be disabled or changed to LPT2 or LPT3 in the
system BIOS setup.
Parallel port connector table (CN14)
Parallel port connector (CN14)
Pin Signal
Pin Signal
1
/STROBE
2 \AUTOFD
3
DO
4
ERR
5
D1
6
\INIT
7
D2
8
\SLCTINI
9
D3
10
GND
11
D4
12
GND
13
D5
14
GND
15
D6
16
GND
17
D7
18
GND
19
\ACK
20
GND
21
BUST
22
GND
23
PE
24
GND
25
SLCT
26
N/C