iLive IT319 - Manual (Page 13)

CUSTOMER HELPLINE | 1-314-621-2881 iLive | IT319B 13
We recommend having this bar speaker
professionally mounted.
The included spacers should be used at your
discretion to extend the face of the bar speaker
farther from the wall. These are typically used
when mounting the bar speaker under a television,
and the face of the bar speaker needs to be flush
with the face of the television.
mounting the Bar sPeaker
important notes
getting started
required tools
Use the Tape Measure to decide how high you’d
like to hang the bar speaker on the wall.
The bar speaker must be hung within 6 feet of an
AC power outlet for the attached AC Power Cord
to reach.
Use the Stud Finder to locate 2 parallel wooden
studs to screw the mounting brackets into.
Mark the wall at the center of the studs using the
pencil.
Line the level up on both of your marks to make
sure they are level. If they’re not, adjust the marks
as needed to make them level.
After you’ve double checked your markings, drill
through the top hole on both mounting brackets
directly into the marks you’ve made on the wall.
If you are using the brackets only and no spacers,
use the included short screws. If you are using any
of the spacers or combination of the spacers, use
the long screws.
Use the Level to level each of the hanging brackets,
then drill the second screw into the bottom hole on
both mounting brackets.
Slide the bar speaker onto the mounting brackets,
and make sure there is a firm and stable connection
before letting go of the bar speaker.
Finally, use the Level to confirm that the bar
speaker is level.
• Manual or Power Screwdriver
• Stud Finder
• Pencil
• Tape Measure
• Level
STUD STUD
 Wall Mount Brackets 
Bracket Placement on Wall
Hanging the Unit
WALL
16 inches