IntraServer Technology 5232E - Manual (Page 31)

31
Table 6 Adapter to Network Hub Wiring
Connection from the ITI-5232E adapter to another network adapter (point to point) must
be made as shown in Table 7:
Crossover
Adapter 1
Pin
Adapter 2
Pin
TX (+) 1
ÇÈ
3 RX (+)
TX (-) 2
ÇÈ
6 RX (-)
RX (+) 3
ÇÈ
1 TX (+)
4 4
5 5
RX (-) 6
ÇÈ
2 TX (-)
7 7
8 8
Table 7 Adapter to Adapter (point to point) Wiring
Cabling Requirements
In order for your network to operate properly, you must use a category of network cabling
that is appropriate for the data rate of the channel. For 10Mb/s operation, Category 3, 4
or 5 cable is appropriate. When operating in 100Mb/s or 100Mb/s Full Duplex, a
Category 5 cable should be used.
The maximum cable segment length supported at 100Mb/sec speed, on Category 5 cable
is 100M. Any single cable segment (adapter to adapter or adapter to network hub) must
be within the 100M length requirement.