Invacare DBPA - Manual (Page 2)

2
FIGURE 1 - ASSEMBLING/ADJUSTING DROP BASE, INSTALLING DROP BASE AND ADJUSTING DROP BASE
HEIGHT, WIDTH AND/OR ANGLE
TOWARDS FRONT
OF WHEELCHAIR
Hook and Loop Faces UP
TOWARDS REAR OF
WHEELCHAIR
Leg Cutout
Crossbrace
Cutout
Base Bracket
Mounting Screws
Base Bracket
Mounting Hook Glides
DETAIL "A"
4. Perform one (1) of the following:
BASE BRACKETS NEED TO BE REPOSITIONED
UP AND/OR DOWN:
A. Remove the two (2) mounting screws that secure
one (1) of the base brackets to the drop base.
B. Rotate base bracket 180 o . Refer to FIGURE 1.
C. Line up the mounting holes in the base bracket
with the mounting holes in the drop base.
D. Reinstall the two (2) mounting screws that secure
one (1) base bracket to the drop base and tighten
securely.
E. Repeat STEPS A-D for remaining base brackets.
F. Continue with STEP 5.
BASE BRACKETS NEED TO BE REPOSITIONED
FORWARD AND/OR REARWARD:
A. Remove the two (2) mounting screws that secure
one (1) of the base brackets to the drop base.
B. Perform one (1) of the following (DETAIL "A" of
FIGURE 1):
ALL BASE BRACKETS EXCEPT 18 AND 20-
INCH FRONT BASE BRACKETS - Reposition
the base bracket to one (1) of two (2) positions.
18 AND 20-INCH FRONT BASE BRACKETS -
Reposition the base bracket to one (1) of three
(3) positions.
C. Line up the mounting holes in the base bracket
with the mounting holes in the drop base.
D. Reinstall the two (2) mounting screws that se-
cure one (1) base bracket to the drop base and
tighten securely.
1-INCH (25MM) DROP (BASE
BRACKET POSITIONED UP)
FLUSH MOUNTING (BASE
BRACKET POSITIONED DOWN)
2-INCH (50MM) DROP (BASE
BRACKET POSITIONED UP)
Mounting Hook
Mounting Screws
Mounting
Hook
Base
Bracket
18 AND 20-INCH DROP
BASE
ALL DEPTHS EXCEPT 18
AND 20-INCH
Base Bracket - (Factory
Installed on Drop Base)
Base Bracket
Rotated 180 o
Abductor Mounting Holes