Invacare Growth Bracket - Manual (Page 2)

2
CURVED BACK
FIGURE 2 - ATTACHMENT POINTS
ULTI-MATE BASE
Standard
Rear of Base
Front of Base
Rear of Base
Option 1 Option 2
Rear of Base
Front of Base Front of Base
Bottom of Back Bottom of Back
Option 1 Option 2
Bottom of Back
Top of Back Top of Back
Standard
Top of Back
ATTACHING / ADJUSTING THE
ADJUSTABLE ANGLE GROWTH
BRACKET (FIGURE 3)
Attaching the Adjustable Angle Growth
Bracket
NOTE: The growth bracket attaches to the child/junior
sized curved back ONLY.
1. Remove the adjustable angle growth bracket and
attaching hardware from the packaging.
2. Unzip the center panel of the back cover, exposing
the six (6) T-nutted mounting holes.
NOTE: Make sure that the growth bracket is positioned
correctly. The flat portion of the adjustable angle bracket
growth bracket provides depth adjustment for the Ulti-
mate base. The angled portion of the adjustable angle
bracket height adjustment for the curved back
(FIGURE 2).
3. Install four (4) of the mounting screws through the
slots in the adjustable angle growth bracket and into
the underside of the Ulti-mate base. Securely tighten.
NOTE: On the Ulti-mate base, the standard attachment
points are the front and rear four (4) holes. Refer to the
FIGURE 2 - ATTACHMENT POINTS in this instruction
sheet for optional attachment points.
4. Install two (2) of the mounting screws through the
slots on the adjustable angle growth bracket and
into the back shell. Securely tighten.
NOTE: On the curved back, the standard attachment
points are the MIDDLE set of holes. Refer to the
FIGURE 2 - ATTACHMENT POINTS in this instruction
sheet for optional attachment points.
5. If adjustment is required, refer to ADJUSTING
THE GROWTH BRACKET in this instruction
sheet.
Adjusting the Growth Bracket
ADJUSTING THE BACK HEIGHT.
1. If necessary, unzip center panel of the back
cover.
2. Loosen the two (2) mounting screws that se-
cure the growth bracket to the back.
3. Adjust the back up or down until the desired
mounting position is obtained.
4. Securely tighten the two (2) mounting screws.