InFocus 61md10 - Manual (Page 13)

Connections & Setup
Chapter 1 11
AUDIO/VIDEO OUTPUTS
FIXED/VARIABLE AUDIO OUTPUTS
• CENTER Provides center surround sound to an A/V receiver or audio
amplifier.
• R and L REAR Provides right and left rear surround sound.
Note : To turn the TV’s internal speakers on and off, press MENU on the
remote control and choose Audio, then Audio Connections. Then
choose Fixed/Variable Out from the menu and choose an option.
• SUBWOOFER Provides lower bass frequencies out from the TV and to a
subwoofer or audio receiver with a subwoofer jack.
Note: Go to Fixed/Variable Output in the Audio Connections menu to
set option to Yes if an external subwoofer is being used.
• R and L Provides right front and right rear mixed sound, and left front
and left rear mixed sound.
INPUT 1
L
R
S-VIDEO
V
FIXED/
VARIABLE
AUDIO
OUTPUTS
CABLE
INPUT
ETHERNET
For Factory Use Only
TV
DIGITAL
AUDIO
OUTPUT
AUDIO/
VIDEO
OUTPUT
V
R
L
SUBWOOFER CTR
R
REAR
L
REAR
MATRIX SURROUND
OUTPUTS
R
L
WIRED
IR
CableCARD™
L
R
S-VIDEO
V
INPUT 3
COMPOSITE
INPUTS
INPUT 2
ANTENNA
INPUT
COMPONENT/
COMPOSITE
INPUTS Use menu for composite video.
L
R
P R
P B
Y/VIDEO
INPUT 4
L
R
P R
P B
Y/VIDEO
HDMI/DVI
INPUT
Use menu for
DVI audio.
POWER
(AC 120V~60Hz)
FIXED/
VARIABLE
AUDIO
OUTPUTS
SUBWOOFER CTR
R
REAR
L
REAR
MATRIX
SURROUND
OUTPUTS
R
L
Explanation of Jacks and Cables
The diagrams that follow illustrate jacks found towards the back of the TV.
When connecting cables, be sure to connect corresponding outputs and inputs
(video input into video out, right audio input into right audio out, etc.).
This section describes the jacks and cables you might use to make connections
(cables may be ordered separately by calling the number on page 82). There
are several ways to connect components to your TV.
Different jacks and cables provide a different level of performance. It’s
important to remember the different degrees of picture quality for comparison.
The HDMI/DVI, DTVLink, and component jacks are considered excellent;
S-Video is very good; composite jacks are good, while connecting components
to the Antenna or Cable Input is fair.