Icom AT-141 - Manual (Page 8)

5
2
INSTALLATIONS
2001 NEW
■ Cable connections
q Connect the coaxial cable and the control cable to
the AT-141 as illustrated below.
w Cover both the antenna and the control cable con-
nectors with rubber vulcanizing tape and fix it with
a vinyl tape to prevent water seeping into the con-
nector.
e Fix both of the coaxial and control cables to pro-
tect the inside connections.
DO NOT pull the antenna and control cable re-
ceptacles. This may cause disconnection (in the
AT-141), internal connector damaged or bad
connection.
r Connect the coaxial cable and the control cable to
the transceiver as illustrated below.
t Ground the transceiver, AT-141 and shield cable of
the control cable via the ground terminal.
• See p. 2 for grounding details.
IMPORTANT!— AT-141
NEVER ground the AT141 via the mounting
plate. It is not connected to ground internally.
Ground terminal
Mounting plate
Rubber vulcanizing tape
AT-141
Icom’s HF transceiver
Grounding
Grounding
AT-141_0.qxd 05.12.1 11:06 Page 5