Coil elements and burner bowls, Lift-up cooktop, Home canning – Inglis Home Appliances Range User Manual

Page 8

Advertising
background image

8

Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed or
dented bottoms could cause uneven heating and poor
cooking results.

Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While you rotate the ruler,
no space or light should be visible between it and the
cookware.

Cookware designed with slightly indented bottoms or small
expansion channels can be used.

Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits
when heated.

Do not cook foods directly on the cooktop.

Hot Surface Indicator Light (under ceramic glass)

The hot surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area(s) is turned off.

Coil Elements and Burner Bowls

(on some models)

Coil elements should be level for optimal cooking results. Burner
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.

Cookware should not extend more than ½" (1.3 cm) over the coil
element. If cookware is uneven or too large, it can produce
excess heat causing the burner bowl to change color. For more
information, see the “General Cleaning” section.

NOTE: Before removing or replacing coil elements and burner
bowls, make sure they are cool and the control knobs are in the
Off position.

To Remove:

1. Push in the edge of coil element toward the receptacle. Then

lift it just enough to clear the burner bowl.

2. Pull the coil element straight away from the receptacle.

3. Lift out the burner bowl.

To Replace:

1. Line up openings in the burner bowl with the coil element

receptacle.

2. Holding the coil element as level as possible, slowly push coil

element terminal into the receptacle.

3. When the terminal is pushed into the receptacle as far as it

will go, push down the edge of the coil element opposite the
receptacle.

Lift-up Cooktop

(on some models)

The lift-up cooktop provides easy access for cleaning beneath.
Do not drop the cooktop. Damage could occur to the finish and
the cooktop frame. For more information, see the “General
Cleaning” section.

To Lift:

Lift the cooktop by both front corners until the supports lock into
place.

To Replace:

1. Lift the cooktop from both sides while pressing the support

rods back to unlock them.

2. Slowly lower the cooktop into place.

Home Canning

When canning for long periods, alternate the use of surface
cooking areas, elements or surface burners between batches.
This allows time for the most recently used areas to cool.

Center the canner on the grate or largest surface cooking
area or element. Canners should not extend more than
½" (1.3 cm) outside the cooking area.

Do not place canner on two surface cooking areas, elements
or surface burners at the same time.

On ceramic glass models, use only flat-bottomed canners.

On coil element models, the installation of a Canning Unit Kit
is recommended. If a kit is not installed, the life of the coil
element will be shortened. See “Assistance or Service” for
ordering instructions.

For more information, contact your local U.S. Government
Agricultural Department Extension Office. Companies that
manufacture home canning products can also offer
assistance.

Advertising