Integra DPC-7.7 - Manual (Page 25)

25
Basic Playback
This section explains how to load and remove discs.
Notes:
• You can load up to six discs. You don’t have to load all
six discs every time.
• When the disc tray is closed, all of the disc indicators
appear until the DPC-7.7 has checked each bay for the
presence of a disc. If a bay is found to have no disc, the
corresponding indicator disappears.
• The disc tray can be opened and closed even while the
DPC-7.7 is in Standby mode, so you don’t have to turn
it on to load or remove your discs. (The disc tray may
take several seconds to open.)
• The DPC-7.7 supports 8 cm and 12 cm discs. To avoid
damaging your discs or DPC-7.7, always place discs
in the center of the disc bays.
• Only load discs that are supported by the DPC-7.7 (see
page 7). Don’t load cartridge-type discs.
• To avoid personal injury, keep your hands away from
the disc tray as it closes.
• Always use the Open/Close [ ] button to open and
close the disc tray. Never push the disc tray, and don’t
touch it, or obstruct it while it’s opening or closing.
Don’t press down on the disc tray while it’s open, and
don’t load anything other than supported discs. Doing
so may damage your discs or DPC-7.7.
Loading & Removing Discs
1 Press the Open/Close [ ]
button.
The disc tray opens and the six disc
number indicators appear on the dis-
play. A circle appears around the num-
ber of the disc bay on the right.
2 Place a disc, label side up, into
each bay.
3 Press the [Disc Skip] button to
access the other disc bays.
The disc tray turns counterclockwise
two bays at a time.
Press the remote controller’s Disc Skip
[+] button to turn the disc tray counter-
clockwise. Press the Disc Skip [–] but-
ton to turn it clockwise.
4 When you’ve finished, press the
Open/Close [
] button again.
The disc tray closes.
See page 26 for information on select-
ing and playing discs.
Enter
Open/Close Open/Close Play
Disc Skip
Disc Skip
DVD CD MP3 WMA JPEG
Remote controller
Remote controller
Remote controller
Tip: If you press the Play [ ] button,
the disc tray will close and playback of
the disc in the right bay will start auto-
matically. If there is no disc in that bay,
the DPC-7.7 will check the other bays
and play the first disc it finds.