Troubleshooting – iHome IH-M183ZW User Manual

Page 6

Advertising
background image

6

troubleshooting

situation try this

mouse

does not

work

Ensure the USB nano receiver is

• 

connected.
1) Remove the USB nano

• 

receiver, then re-connect it to

your netbook, 2) Press the right

button on your mouse, then press

the scroll button. Your mouse

should now be active.
Connect the USB nano receiver

• 

to a different USB port.
Ensure the battery is inserted

• 

correctly into the battery

compartment.
Install a fresh battery.

• 

Move the mouse closer to the

• 

USB nano receiver.
Ensure the laser sensor on the

• 

bottom of the mouse is clean.

FCC Statement

This device complies with part 15 of FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instruction guide, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and the receiver.

• 

Connect the equipment into an outlet on a circuit different from

• 

that to which the receiver is connected.

Consult a service representative for help.
Properly shielded and grounded cables and connectors must be
used in order to comply with FCC emission limits. LifeWorks is not
responsible for any radio or television interference caused by using
other than recommended cables and connectors or by unauthorized
changes or modifications to this equipment. Unauthorized changes
or modifications could void the user’s authority to operate the
equipment.

Advertising
This manual is related to the following products: