Invacare Compressor - Manual (Page 17)

SECTION 3—INITIAL SETUP
Part No 1100873 17 HomeFill ® Compressor
Transporting the Compressor
ƽ WARNING
NEVER transport a compressor with a cylinder connected to or
stored on the compressor, otherwise injury or damage can occur.
CAUTION
When transporting the compressor, be careful not to bump the
compressor or the connectors into obstacles. Otherwise, damage
to the compressor may occur.
NOTE: For this procedure, refer to FIGURE 3.1.
1. There are two methods to
safely transport the
compressor:
• One Hand ‐ Grasp the
hand grip at the
bottom rear of the
compressor.
• Two Hands ‐ Grasp the
hand grips on the sides
of compressor.
FIGURE 3.1 Transporting the
Compressor
Installing the Power Cord
NOTE: For this procedure, refer to FIGURE 3.2 on page 18.
1. Choose a proper location. Refer to Choosing a location on
page 16.
2. Make sure the power switch is in the Off (O) position
3. Plug the power cord into the electric connector in the back of
the compressor.
4. Plug the opposite end of the power cord into the wall outlet.
Hand Grip
Hand Grip
Hand Grip