iLive T SERIES AP6526 - Manual (Page 14)

14 ALLEN & HEATH iLive Reference Guide AP6526 iss.3
An IEC mains power cord with moulded plug suitable for your territory is provided for
each power supply module within the system. The iLive system uses universal voltage
power supplies that accept world wide mains sources from 100 to 240V.AC 47 to 63Hz.
Make sure the IEC plugs are pressed fully into their panel sockets and the cables are
clipped into the retaining clips to protect them from accidental disconnection.
Note: To ensure operator safety, connect only to an approved and properly
grounded mains source. Do not remove the ground connection in the mains cord.
Note: Read and understand the warnings in the safety sheet supplied with the
equipment and printed on the power unit panels.
Note: It is good practice to connect both the MixRack and the Surface to the same
mains power ring or feed, and to use a UPS (uninterruptible power supply) as a backup
in critical applications where there is any risk of mains or generator power being
interrupted.
MAINS FUSE - In the event of a fuse failure replace only with the correct type and
rating as indicated on the rear panel. If the replacement fuse fails again, switch off and
refer to your Allen & Heath service agent.
ON/OFF switch - Press to switch mains power on or off. Blue status LED indicators
light on the power supplies and modules to indicate that power is present and correct.
iPS10 backup power supply - The optional iPS10 rack mounted power supply unit
may be connected to the Surface or iDR0 MiniRack as a redundant backup if required.
The iDR10 MixRack already has provision for a second backup supply module.
Female plug
Male plug
TEMPERATURE MONITOR CABLE
DC CABLE CAT5
10way
MAINS
Female plug
Male plug
MAINS
iDR0 MINIRACK
INTERNAL PSU
iLIVE SURFACE
iPS10 BACKUP PSU
TEMPERATURE MONITOR CABLE
DC CABLE
IEC MAINS CABLES
CAT5
10way
MAINS
INTERNAL PSU
Mains power 100 - 240V AC
iPS10 BACKUP PSU
IEC MAINS CABLES
Mains power 100 - 240V AC