Impex MD-8850 - Manual (Page 13)

STEP 4 (See Diagram 4)
A.) Attach the 128” Cable (#24) to the open Pulley bracket on Rear Base Frame (#4).
B.) Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#48), two Ø ¾”
Washers (#52), and one M10 Aircraft Nut (#54).
C.) Draw the Cable around the Pulley then upward to the Double Floating Pulley Brackets
(#25) installed in Step-3. Repeat B to install a Pulley.
D.) Draw the Cable around the Pulley then downward to the open hole on the Weight
Glide Base (#7). Secure the end of the Cable to the open hole with M10 x 4” Allen Bolt
(#47), two Ø ¾” Washers (#52), and one M10 Aircraft Nut (#54).
E.) Adjust the tension of the Cable system by adjusting the Pulley position on the Double
Floating Pulley Brackets. If the Cable is too loose, move up the Pulley one hole. If the
cable is too tight, move down the Pulley one hole.
F.) Connect the Shiver Bar (#27) to the Cable with two Hooks (#56) and one 15-link Chain
(#58).
DIAGRAM 4
12