Ide Line 740-108 - Manual (Page 12)

ASSEMBLING THE VACUUM
CLEANER:
Fitting the tube:
- Press the buttons on the end of the
tube and insert the tube into the air-
intake.
Removing the hose:
- To release the hose, press the buttons
on the end of the hose and pull the
hose firmly from the air intake duct.
FLOOR BRUSH USE
- Press the button on the floor brush, so
the brush is shown for cleaning hard
floors
- Press the other button to withdraw the
brush for cleaning carpets.
OPERATION
- Do not remove the plug from the socket
by pulling the cable or the appliance
itself.
- Do not run the appliance over the
power cable.
- Do not use the appliance to vacuum up
lit matches, cigarette ends or hot ashes.
- Do not use the appliance on wet
surfaces.
- Do not obstruct the air intake or the air
outlet vents.
- Do not use the appliance to vacuum up
needles, drawing pins or string.
INSTRUCTIONS FOR USE
- Before using the appliance, unwind a
sufficient length of cable and insert the
plug into the power socket. A yellow
mark on the power cable shows the
ideal cable length. Do not extend the
cable beyond the red mark.
To rewind the power cable, press the
rewind button with one hand, and guide
the cable with the other hand to ensure
that it does not whip causing damage.
- Press the ON/OFF button to switch the
appliance on.
- The vacuum cleaner’s three special
nozzles can be stored in the storage
compartment (14). Remove the floor
nozzle and fit the special nozzle
required to the end of the telescopic
tube. Note: The brush nozzle (18) must
be placed over the joint nozzle (17).
Close the cover again before turning
the vacuum cleaner on (the buttons (15)
must be clicked in place).
- While in use, the suction force can be
regulated by opening and closing the
air valve on the handle or adjusted
electronically using the suction force
regulation slider (13).
REPLACING THE DUST BAG:
After removing the hose, open the front
cover by pressing the lock lever and pulling
upwards.
Remove the dustbag-holder.
Remove the dustbag from the holder.
Replace the dustbag by inserting the
carton of the dustbag into the grooves of
the dustbag-holder.
REPLACING THE MOTORFILTER
The motor-filter is the filter placed behind
the dustbag:
Open the front cover, and gently pull out
the filter free of the holder.
Insert a new motor-filter.
12
IM 06/01/05 8:25 Side 12