Indesit DG 6145 - Manual (Page 11)

9
GB
Cleaning and Special Maintenance
Filter Assembly
For best performance and results, the filter assembly must
be cleaned.
The filter efficiently removes food particles from the wash
water, allowing it to be recirculated during the cycle. For
this reason, it is a good idea to remove the larger food
particles trapped in the filter after each wash cycle by rinsing
the "A" semi-circular filter and cup under running water.
To remove the filter assembly, pull on the cup handle in the
upward direction. The entire filter assembly (made up of
the "A"
semicircular filter
and the "B" fine
filter) should be
cleaned at least
once a month.
To clean the filter
and the fine filter,
use a cleaning
brush.
Then, reassemble
the filter parts as shown in the figures below and reinsert
the entire assembly in the dishwasher, positioning in its
seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of
the filters may reduce the
performance level of the
appliance and damage
dishes and utensils.
Cleaning the Sprayer
Arms
It may happen that food
particle become encrusted
on the sprayer arms and
block the holes. Check the sprayer arms periodically and
clean them when needed. (See close-up view (interior)
lett.F-I)
Cleaning the Water Inlet Filter
Periodically clean the water inlet filter (see figure 2 under
"Installation") located on the outlet of the water supply
tap.
After turning off the water tap, unscrew the end of the
water supply hose, remove the filter and clean it carefully
under running water. Then, return the filter to its place and
tighten the water supply hose back into position.
Troubleshooting
It may occur that the dishwasher does not function or does
not function properly. Before calling for assistance, let us
see what can be done first: have you forgot to press one of
the buttons or to perform an essential operation?
The Dishwasher Does Not Start
Have you checked whether:
- the plug is pushed into the socket correctly;
- the power is on in the house;
- the door is closed properly;
- the ON-OFF switch is on "ON";
- the water supply is turned on.
The Dishwasher Does Not Load Water
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient
pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishes Are Not Clean
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient
pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishwasher Does Not Drain
Have you checked whether:
- the drain hose is crimped or bent.
Lime Deposits or a White Film Form on the Dishes
Have you checked whether:
- the lid to the salt container is closed properly;
- the rinse aid dosage is correct.
If, despite all these checks, the dishwasher still does not
function and/or the problem persists, contact the nearest
authorised service centre and provide them with the
following information:
- the nature of the problem;
- the model type number (Mod. ...) and the serial number
(S/N ....), which are indicated on the plate located on the
side of the inner part of the door.
Never call on unauthorised technicians and refuse to
allow parts to be installed that are not original spare
parts.
A
B