ILY Enterprise CoolCopy 7 User Manual

Page 28

Advertising
background image

Copyright

©2005 by ILY Enterprise Inc.

All Rights Reserved.

28

System will search the new firmware from the

CD and the LCD will show the process as left.

When find the new firmware, just press “ENT”

button. The system will update it.

4.12.8 Compare Firmware

This function will help you compare your current control firmware version and the updated version

in your firmware disc that you insert into the CD-ROM.

Press “ENT” button to enter “Compare Firmware”

and “ESC” to exit.

.

4.12.9 H/W Diagnostic

This function will detect which types of devices are connected with the control. The LCD will show

the hardware information.

Press the ENT button to enter “H/W Diagnostic”

and “ESC” to exit.

LCD will ask user to do the button test. Following

the LCD instruction test each function button.

After the button function testing, the system will self-test SDRAM, the hardware connecting test,

and flash test. Every testing process will be shown on the LCD. It just takes a few minutes to get

the results of hardware diagnostics. It is an easy way to know if the system works properly.

When testing is finished, the LCD will show the

“Test finished” message. Press “ESC” button to

go back 12-09 menu.

4.12.10 Load Default

This function will reset whole previous setting back to factory’s default setting. Different settings

will cause duplicator to react differently.

Press “ENT” button to enter “Load Default” and

“ESC” to exit.

Use the arrow button to change settings. When

“Yes” is selected, the duplicator will return to

factory’s default setting.

The LCD message will show that the setting has

been changed by with the follow message:

Searching F/W---

XXX/XXXXX

12-08. Adv Setup

Compare Firmware

12-09. Adv Setup

H/W Diagnostic

Enter ESC

Hold ESC to exit

Test finished

12-10. Adv Setup

Load Default


Load Default

Config? Yes
Load Default

OK

Advertising
This manual is related to the following products: