Indesit IDTM - Manual (Page 4)

4
EN
Electrical Connection
If your appliance is supplied with a 13 amp. fused
plug it can be plugged into a 13 amp socket for
immediate use. Before using the appliance please
read the instruction below.
 Warning
Warning Warning Warning Warning:this appliance must be earthed.
Thed following operations should be carried out by a
qualified electrician.
Replacing the fuse
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be used,
and the fuse cover re-fitted. If the fuse cover is lost,
the plug must not be used until a replacement is
obtained.
Replacemente fuse covers
If a replacement fuse cover is fitted, it must be of
the correct colours as indicated by the coloured
marking or the colour that is embossed in words on
the base of the plug. Replacements can be obtained
directly from your nearest Service Depot.
Removing the plug
Ifyour appliance has a non-rewireable moulded plug
and you should wish to remove it to re-route the
mains cable through partitions, units etc., please
esure that either:
- the plug is replaced by a fused 13 amp re-wireable
plug bearing the BSI mark of approval
or:
- the mains cable is wired directly into a 13 amp
cable outlet, controlled by a switch, (in
compliance with BS 5733) which is accessible
without moving the appliance.
Disposing of the plug:
Ensure that before disposing of the plug itself, you
make the pins unusable so that it cannot be
accidentally inserted into a socket.
Instruction for connecting cable to an altenative
plug
Important: the wires in the mains lead are coloured
in accordance with the following code:
Green & Yellow
- Earth Earth Earth Earth Earth
Blue - Neutral Neutral Neutral Neutral Neutral
Brown - Live Live Live Live Live
 Caution: Caution: Caution: Caution: Caution: The dishwasher plug must be accessible
even when the appliance is installed as a built-in unit
so that maintenance can be done safely.
As the colours of the wires in the mains lead may
not correspond with the coloured markings
identifying the terminal in your plug, proceed as
follows:
•
connect Green & Yellow wire to terminal market
“E
E E E E” or coloured Green or Green & Yellow.
• Connect Brown wire to terminal marked “L L L L L” or
coloured Red.
• Connect Blue wire to terminal marked “N N N N N” or
coloured Black.
If a 13 amp plug (BS 1363) is used it must be fitted
with a 13 amp fuse. A15 amp plug must be
protected by a 15 amp fuse, either in the plug or
adaptor or at the distribution board.
If you are in any doubt about the electrical supply to
your machine, consult a qualified electrician before
use.
How to connect an alternative plug
The wires in this
mains lead are
coloured in
accordance with the
following code:
• BLUE “NEUTRAL” (“N”) “NEUTRAL” (“N”) “NEUTRAL” (“N”) “NEUTRAL” (“N”) “NEUTRAL” (“N”)
• BROWN “LIVE” (“L”) “LIVE” (“L”) “LIVE” (“L”) “LIVE” (“L”) “LIVE” (“L”)
• GREEN AND YELLOW “EARTH” (“E”) “EARTH” (“E”) “EARTH” (“E”) “EARTH” (“E”) “EARTH” (“E”)
Disposing of the appliance
When disposing of the appliance please remove the
plug by cutting the mains cable as close as
possible to the plug body and dispose of it as
described above
GREEN &
YELLOW
BROWN
BLUE
13 amp fuse
CROSS-BAR
CORD GRIP