iHome iH7 - Manual (Page 7)

iH7_USB_3 inserts_IB_12210.fh10 7/16/09 1:12 PM Page 7
Install/Replace the Remote Control Batteries
The remote control batteries are already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the batteries with new ones.
1. The battery door is located on the back end of the unit.
2. Press to release the battery door latch.
3. Insert two “CR2032” 3-volt lithium batteries. Make sure the polarity (the + and – side
of the battery) is correct.
4. Replace the battery holder back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Using The Remote Control Unit
Button
Button ..............
Presets Select Button
EQ Button ..............Set Treble, Bass and Balance
settings for best sound
Radio Button ..........Selects Radio function, AM and
FM1 and FM2 radio bands
Snooze/Dimmer Button
CHANGING THE REMOTE CONTROL CODE
The iH7 has 4 DIP switches located in the backup battery compartment (see page 4) and in the remote control battery
compartment. If you experience interference from other remotes or have more than one iH7 operating at once, you may
need to change the DIP switch settings (DIP settings on remote and base unit must always match). To do so:
a) open the battery compartment on both the remote control and the iH7.
b) check that all DIP switch positions on unit and remote control match
c) use fingernail or small object such as a paperclip tip to move ONE of the switches on the unit to a different position.
Do the same on the remote, making sure to move the same switch to the same position so the switches on each match.
d) turn the unit on AFTER changing the DIP switch position for the new code to take effect. If the DIP switch is changed
while unit is on, turn unit off then back on.
e) test performance. If interference is still an issue, adjust DIP switch settings again.
.....Lowers volume level Volume
_
Button
.....Raises volume level Volume + Button
Battery
door
DIP switches
The Remote Control controls basic functions on the iH7 and certain iPod ® functions when the iPod ® is docked in the iH7.
For best results, use the remote control within 30 feet of the unit.
5
Power On/Off Alarm
Reset Button
Turns iH7 ON or OFF
or reset alarm when
alarm is sounding
Skip to previous or next track when
iPod is playing, or HOLD to scan
current playing track. In radio mode,
press to tune stations. HOLD to scan
radio stations.
Cycles through AM
or FM radio presets
Snooze mode when
alarm sounds,
otherwise dims
display
Mute Button Mutes volume
iPod Play/Pause Button Selects iPod and
plays track. In play
mode , press to pause