Infinity DMC 1000 User Manual
Page 104
104
DMC 1000 Digital Media Camcorder User’s Guide (v1.15)
Chapter 11 - Specifications
Sensitivity
2000 lux (186 ft cd) at F8 typical
Gain
-6 to +42 dB (user-definable presets) and variable master gain
between -6 and +42 dB in 0.1 dB steps.
Audio
Range from 20 Hz to 20 kHz (unweighted), 24 bits PCM, 48 kHz,
dynamic range 85 dB
Compression
DV25
PAL (4:2:0) and NTSC (4:1:1)
JPEG2000
SD
HD
10-bit, 4:2:2
10-bit, 4:2:2
30 Mb/s, 40 Mb/s and 50 Mb/s
50 Mb/s, 75 Mb/s and 100 Mb/s
MPEG-2 i-frame (requires optional
DMC 1100 MPEG-2 board)
SD
HD
8-bit, 4:2:0
8-bit, 4:2:0
30 Mb/s, 40 Mb/s and 50 Mb/s
60 Mb/s and 80 Mb/s
File formats
High quality content
MXF OP-1A (SMPTE 378M), including 4 channels of PCM audio and
metadata
Metadata
Compatible with SMPTE Metadata Dictionary RP210
Built-in storage media
REV drive
Grass Valley REV PRO disk drive
CompactFlash
2x type I and II CompactFlash slots, speed depending on media
Camcorder connectors
Front microphone input
1x XLR-3 female, balanced, +48 V phantom or 1x XLR-5 female,
balanced, +48 V phantom (requires DMC 1180/00 option)
Rear audio inputs
2x XLR-3 female, mic/line-level, balanced, switchable +48 V phantom
Additional audio inputs
2-channel AES/EBU audio (via BNC), 1channel (via wireless receiver
slot) and 8 channels SDI (from SDI input)
Audio outputs
1x XLR-5 male, line-level, 2-channel mixed balanced
6.3 mm stereo jack headphones
Additional audio outputs
2-channel AES/EBU or embedded (HD-)SDI 8 channel audio via BNC
connector.
Lens connector
12-pin female Hirose interface connector
Viewfinder connector
HDMI type A connector
(HD-)SDI input
BNC connector SMPTE 292M (1.5 Gb/s) or SMPTE 259M (270 Mb/s),
0.8 Vpp, 75
Ω
(HD-)SDI output
BNC connector SMPTE 292M (1.5 Gb/s) or SMPTE 259M (270 Mb/s),
0.8 Vpp, 75
Ω
Analog video input
BNC connector CVBS, Blackburst, Linear Timecode or AES/EBU
audio, 1.0 Vpp, 75
Ω
Analog video output
BNC connector CVBS, Linear Timecode or AES/EBU audio, 1.0 Vpp,
75
Ω
DC 15 V input
XLR-4 male (11.0 to 17.0 VDC)
DC 12 V output
4-pin female Hirose connector, nom. 12 V 1.0 A with Tally-signal
IT-connectivity
Item
Value