Insignia NS-A1111 - Manual (Page 6)

6
Insignia NS-A1111 5-CD Shelf System
www.insignia-products.com
Display
Setting up your shelf
system
Preparing the remote control
Installing remote control batteries
I
I
To install batteries in the remote control:
1 Remove the battery cover.
2 Insert one CR2025 (3-volt) battery into the
battery compartment. Make sure that the +/–
symbols on the battery match the +/– marks
inside the battery compartment.
3 Replace the battery cover.
4 Remove the plastic tab covering the remote
control sensor.
5 Point the remote control at the remote sensor
on the shelf system. The effective distance
for remote operation is about 16 feet (5
meters).
Tuning (down) button Press to adjust radio setting
from a higher to lower
frequency.
TIMER button Press to set a timer alarm.
Volume +/- buttons Press to adjust the volume.
Disc skip button Press to skip playing an
entire disc loaded in the CD
changer.
Tuning (up) button Press to adjust radio setting
from a lower to higher
frequency.
Play/pause button Press to start or resume
playing a disc.
Press to pause playback of
disc.
Skip forward/preset+
button Press to start, pause, or
resume playing a disc.
Repeat button Press to replay a track.
Band button Press to switch between AM
and FM radio bands
Function button Press to switch between CD,
tuner, and aux in.
Indicator Description
Band Displays FM or AM radio band.
Clock AM/PM Indicates that the time is AM or PM.
Clock/CD track/
broadcast station • In clock mode, displays the time.
• In CD mode, displays the track
number.
• In broadcast station mode,
displays the station number.
MEMORY Displays when the track being played is
stored in memory.
STEREO Indicates that the FM signal is playing in
stereo.
REPEAT mode Displays when the repeat feature is in
use.
Radio frequency Shows whether the radio frequency is
megahertz or kilohertz.
Control Symbol Description
Band
Clock
AM/PM
Clock/CD
track/
broadcast
station
STEREO
Repeat
mode
Radio
frequency
MEMORY
Warning
Do not throw the batteries into fire. Dispose of used
batteries as hazardous waste.
Caution
Do not drop or disassemble the remote control. Do not
get the remote control wet.
Note
When using the remote control and you are
required to move closer to the stereo for the
remote control to operate, replace the battery. The
remote control may not operate correctly if direct
sunlight or the light of a high-frequency fluorescent
lamp enters the remote control light sensor. In this
case, change the system installation position to
prevent the problem.
Note
When the remote control will not be used for a long
period of time or when the batteries are worn out,
remove the batteries to prevent leakage.
NS-A1111_final_translationDTP.fm Page 6 Friday, February 17, 2006 12:09 PM