IBM Partner Pavilion T400F - Manual (Page 96)

Removing a Fibre Channel Tape Drive from an Enclosure
To remove an IBM TotalStorage LTO Ultrium 2 Tape Drive Model T400F from an
enclosure, perform the following steps:
1. Ensure that the tape drive does not contain a tape cartridge.
2. Deconfigure the drive from the server, switch, or hub (for instructions, see the
documentation for these devices).
3. Turn off the power to the enclosure. Disconnect the power cable from the
enclosure and the electrical outlet.
4. Disconnect the internal power cable from the power connector (see 1 in
Figure 29).
5. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
connector 6 .
6. Disconnect the internal fiber cable from the Fibre Channel connector 5 .
7. Disconnect the LID/status connector 3 .
8. Disconnect the FC configuration/status connector 4 .
9. Remove the mounting screws from the side brackets of the chassis (see 2 in
Figure 8 on page 26).
10. Remove the tape drive from the enclosure.
11. To reassemble, reverse these steps.
Figure 29. Rear view of the IBM TotalStorage LTO Ultrium 2 Tape Drive Model T400F (Fibre
Channel drive)
84 IBM TotalStorage LTO Ultrium 2 Tape Drive