ICP DAS USA MSM-6226 - Manual (Page 86)

reinitializing LLDP transmission. (Default: 2 secs)
Notification
Interval: The minimum interval for LLDP data change Notification fpr the
same neighbor. Refer to IEEE 802.1AB-2005 or later for more
information. (Default: 5 secs)
Mode : To enable or disable the LLDP mode per port. There are four
type includes Disable, Tx_Rx, Tx only and Rx only
Port Descr : To evoke the outbound LLDP advertisements, includes an
alphanumeric string describing the port.
Sys Name : To evoke the outbound LLDP advertisements, includes the
system’s assigned name
Sys Descr : To evoke outbound LLDP advertisements, includes an
alphanumeric string describing the full name and version
identification for the system’s hardware type, software version,
and networking application.
Sys Capa : To evoke outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported. Also
includes information on whether the capabilities are enabled.
Mgmt Addr : To evoke outbound advertisements, includes information on
management address. you can use to include a specific IP
address in the outbound LLDP advertisements for specific ports
Notification : Default: Disabled.
Enables or disables each port for sending notification to
configured SNMP trap receiver if an LLDP data change is
detected in an advertisement received on the port from LLDP
neighbor.