Install the monitor, Power cord – IBM E54 User Manual
Page 2
E-2
INSTALL THE
MONITOR
•
To connect the tilt/swivel base to the monitor,
align hooks with the sockets on the bottom side
of the monitor, and gently push the base towards
the front of the monitor.
•
The 15-pin D-shell signal connector on the signal
cable connects easily to the video adapter output
on your computer. Lock both screws on the
connector to ensure a firm connection.
•
Turn the computer power switch to ON. Then turn
the monitor power switch to ON by pressing the
switch inward. The green power light-emitting
diode (LED) will light.
•
Allow about 30 seconds for the CRT tube to warm
up. Data will display on the screen.
•
If your display fails to function properly, refer to
the “Troubleshooting” section in this manual.
POWER CORD
•
Check first to make sure that the power cord you
use is the correct type required for your area.
•
This monitor has a universal power supply that
allows operation in a 100/120 V ac or 220/240 V
ac voltage area. No user-adjustment is required.
•
First connect the power cord into your monitor
power input socket, and then plug the other end
into a 3-pin ac outlet. The power cord can be
connected to a wall outlet or the power output
socket on your computer, depending on the type
of power cord supplied with your monitor.
•
For units to be used at 120 V ac:
Use a UL-Listed Cord Set consisting of a
minimum No. 18 AWG, Type SVT or SJT three-
conductor that is 4.5 m (15 ft) long and a parallel
blade, grounding-type attachment plug rated 10
A, 125 V.
•
For units to be used at 240 V ac (domestic use):
Use a UL-Listed Cord Set consisting of a
minimum No. 18 AWG, Type SVT or SJT three-
conductor cord a maximum of 4.5 m (15 ft) long
and a tandem blade, grounding-type attachment
plug rated 10 A, 250 V.
•
For units to be used at 220/240 V ac (outside of
the United States):
Use a Cord Set consisting of a mininum No.18
AWG cord and grounding-type attachment plug
rated 15 A, 250 V. The cord set must have the
appropriate safety approvals for the country in
which the equipment will be installed and marked
HAR.
113393-0A-E.pm6
8/1/00, 6:38 PM
2