iHome iH70 - Manual (Page 6)

3
Using iH70
Install AC Adaptor
Connect the AC adaptor cable plug into the jack on the back of the left speaker, then plug
the AC adaptor into the wall outlet.
Install iPod Insert
Your iH70 comes with inserts to ensure your iPod fits properly in the dock.
To place an insert:
1. Select the insert for your iPod (see table on page 1).
2. Gently press the iPod insert into the dock.
3. Carefully place your iPod into the dock. The iPod must not be in a case or “skin”. Install iPod Insert
Charging Your iPod
Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert) and that it is properly docked
into the iH70.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. iPod will
not be overcharged.
1. Dock an already playing iPod and the iH70 will automatically turn on.You will hear the music playing from your iPod.
Note: If the volume on the playing audio is too low on the iPod itself, the iH70 may not detect that the iPod is in play
mode. Press the button on the right speaker once to play iPod.
2. When the iPod is docked and in standby mode, press the button on the iH70 then press play/pause on your iPod
to play it.
3. Press play/pause on your iPod to pause play; press again to resume it.
4. Press the or buttons on the right speaker to adjust the system volume.
5. To turn off the unit, press the button on the right speaker. Your iPod will continue charging while in the dock.
NOTE: IF YOU PLAY YOUR iPOD AND A COMPUTER AUDIO SOURCE AT THE SAME TIME YOU WILL HEAR BOTH
The iH70 has two input jacks located on the back of the left speaker, a computer audio jack and an Aux in jack. Use the jack
marked “to computer” to listen to audio output from your computer. If you are using an iPod without a docking port or other
MP3 player/ audio device, you can play it through the iH70 via the Aux-in Jack.
NOTE: DO NOT PLAY AUDIO FROM TWO SOURCES AT THE SAME TIME OR YOU WILL HEAR BOTH
1. Plug one end of the computer audio cable (included) into the headphone, speaker or line-out jack on your computer and
the other end of the cable into the iH70 To Computer Jack.
2. Press the button on the right speaker to turn the iH70 on.
3. Press the or buttons on the right speaker to adjust the system volume. You may need to adjust your device volume,
too.
4. To turn off the unit, press the button on the right speaker.
Listening to Your iPod
Listening to Computer Audio