Indesit KD641G - Manual (Page 31)

UNPACKING THE COOKER
Unpack the components from inside the grill and oven.
Check that the following parts are present:
Grill pan and grid Top oven/grill shelf heat shield ( Models KD643G and KD641G )
Pan supports (2) Top oven/grill shelf (1) ( Models KD643G and KD641G )
Main oven shelves (2) Aluminium burner bodies (4)
Enamelled burner caps (4) Literature
LEVELLING
Two rear wheels and two front feet are fitted which can be adjusted up or down to set the
height (900mm - 915mm) and level the cooker.
1.
The rear wheels can be raised or lowered from the BACK of the cooker by adjusting
the levelling screws ‘A’ in the plinth.
2. The front feet can be simply screwed in or out to lower or raise the front of the
cooker.
CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.
VIEWED FROM THE REAR
31
STABILITY BRACKET
The back of the cooker has a slot for engagement of a stability bracket, which can be
obtained, as an extra, from your cooker supplier.
125mm
STABILITY
BRACKET
POSITION
SLOT FOR STABILITY BRACKET
REAR OF
COOKER
Installation Instructions