Infinity TSS-CENTER4000 - Manual (Page 5)

5 TSS-CENTER4000
W
IRING THE
S
PEAKER
After placing the speaker, you are ready to connect it to your
system. First, turn off all audio system power. Use high-quality
speaker wire to make the connections. Consult the owner’s
manuals included with your amplifier or receiver for connection
and operation procedures.
Surround Modes
When using the TSS-CENTER4000 in a Dolby* Digital or DTS ®
home theater system, make sure the receiver’s/processor’s
center channel speaker modes are set to “Small.”
Wiring and Polarity
The TSS-CENTER4000 speaker has gold-plated terminals that
can accept bare wire.To ensure proper polarity, connect each
+ terminal on the back of the amplifier or receiver to the
respective + (red) terminal on each speaker, as shown in
Figure 4. Connect the – (black) terminals in a similar way.
See the owner’s manuals that were included with your
amplifier or receiver to confirm connection procedures.
Important!
Do not reverse polarities (i.e., + to – or – to +) when making
connections. Doing so will degrade the imaging and bass
response of the home theater system.
After correctly placing and wiring the TSS-CENTER4000 and
the rest of your speaker system, adjust the levels for all of the
channels as recommended by the manufacturer of your
receiver/processor.
Figure 4. This example shows how to connect bare wires to the
terminals. Banana plugs may also be inserted directly into the
rear of the connector.
ᕡ Loosen the terminals.
ᕢ Insert bare ends; tighten terminals.
– +
ᕡ ᕢ
C
ARE OF
Y
OUR
S
PEAKER
S
YSTEM
When needed, use a soft cloth to remove any fingerprints or
to wipe off dust. Do not use any cleaning products or polish.
Clean the grille by gentle vacuuming.
INFP1594Center-4000om 10/18/04 2:34 PM Page 5