Impex PHC-PWR9 User Manual
Powerhouse club, Power 9, Model phc-pwr9
Advertising
Table of contents
Document Outline
- BEFORE YOU BEGIN...................................................................................... 1
- IMPORTANT SAFETY NOTICES..................................................................... 2
- HARDWARE PACK……….....…....................................................................... 3
- ASSEMBLY INSTRUCTIONS........................................................................... 5
- EXPLODED DIAGRAM.........................................................................………. 18
- PARTS LIST………………………………………………………………………….. 20
- WARRANTY.................................................................................................… 21
- ORDERING PARTS......................................................................................... 21
- HARDWARE PACK
- ASSEMBLY INSTRUCTION
- Connect the two Rear Upright Beams (#48) by a Rear Stabilizer (#53). Secure each end with one M10 x 3 ¾” Carriage Bolt (#83) to the upper hole, one M10 x 3 3/8” Allen Bolt (#82) to lower hole, one 4” x 2” Bracket (#64), two ( ¾” Washers (#42), and one M1
- Attach the upper end of a Rear Upright Beam (#48) to an Upright Beam (#47). Secure it with one M10 x 3 ¾” Carriage Bolt (#83), ( ¾” Washer (#42), and M10 Aircraft Nut (#44). Repeat the same procedure to install the other side.
- DIAGRAM 6
- PARTS LIST
- KEY NO. DESCRIPTION Q’ty