Invacare 300 - Manual (Page 68)

SECTION 14—SCOOTER ACCESSORIES
Zoom ™ 300 and Zoom ™ 400 68 Part No. 1118395
INSTALLING/REMOVING THE REAR MOUNTED
BASKET
NOTE: For this procedure, refer to FIGURE 14.6.
ƽ WARNING
The rear mounted basket is rated for a maximum capacity of ten (10) lbs.
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely.
The installation of the basket and basket bracket onto the back of the scooter seat
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to surrounding property may occur.
INSTALLING
1. If necessary, loosen but do not remove the mounting knob.
2. Install the basket bracket into the accessory tube.
3. Thread the mounting knob into the welded nut on the accessory tube. Securely
tighten.
4. Align the mounting clips on the bracket with the slots on the basket and slide the
basket DOWN securely into position.
REMOVING
1. Remove the basket from the bracket.
2. Loosen the mounting knob.
3. Remove the basket bracket from the accessory tube.
4. Tighten the mounting knob.
FIGURE 14.6 - INSTALLING/REMOVING THE REAR MOUNTED BASKET
Seat
Accessory Tube
Mounting
Knob
Rear Basket
Slots
Basket Bracket
Mounting Clips