iSimple IS76PRO - Manual (Page 4)

A division of AAMP of America™
13190 56th Court Clearwater
Florida 33760
Ph. 866-788-4237
[email protected]
©2010 AAMP of Florida, Inc.
www.isimplesolutions.com
6. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty applies only
to the original purchaser of this product from an authorized iSimple ® dealer. This warranty covers any supplied or
manufactured parts of this product that, upon inspection by iSimple ® authorized personnel, is found to have failed in
normal use due to defects in material or workmanship. This warranty does not apply to installation expenses. Attempting
to service or modify this unit, operating this unit under conditions other than the recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple® shall not be liable for any personal injury, property damage and
or any incidental or consequential damages of any kind (including water damage) resulting from malfunctions,
defects, misuse, improper installation or alteration of this product. All parts of this iSimple ® product are guaranteed
for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above, iSimple ® will repair or replace
the product at our discretion, if it is defective in material or workmanship providing it is returned to an Authorized
iSimple TM dealer, with PROOF OF PURCHASE from an authorized iSimple ® dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation. Exposure to direct sunlight or
extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the
user authority to operate the equipment.
“Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic accessory has been designed to connect
specifically to iPod, iPhone, or iPad, respectively, and has been certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with iPod, iPhone, or iPad may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other
countries. iPad is a trademark of Apple Inc.
For Best Performance Have It
Professionally Installed.