InFocus UC 18SD - Manual (Page 8)

English
8
APPLICATIONS
For charging the HITACHI battery types EB1414 (For UC14SD) and EB1812S (For UC18SD).
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
⅜ The power source voltage is stated on the nameplate.
⅜ The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig.
2. Make sure it contacts the bottom of the battery charger.
2. Insert the plug of battery charger into the receptacle.
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
3. Charging
⅜ When the plug of battery charger has been inserted into the receptacle, charging will
commence and the pilot lamp will light on.
NOTE: If the pilot lamp does not light, pull out the plug from the receptacle and check
if the battery is properly mounted.
⅜ In approx. one hour, when the battery is fully charged, the pilot lamp will go out.
NOTE:
⅜ The battery charging time becomes longer when a temperature is low or
the voltage of the power source is too low.
When the pilot lamp does not go off even if more than four hour has passed
after start of the charging, stop the charging and contact your HITACHI
AUTHORIZED SERVICE CENTER.
Fig. 2
UC14SD