Invacare 9000 Topaz - Manual (Page 63)

11 OPTIONS
Part No 1100869 63 Invacare®9000 Topaz™Wheelchair
Installing
1. If necessary, remove the two existing swingaway footrest assemblies from the wheelchair by performing the following:
A. Push the footrest release lever inward.
B.
Rotate swingaway footrest assembly outward.
C. Lift the swingaway footrest assembly off of the hinge pins.
D. Repeat STEPS A-C for the other footrest assembly.
2. With the footboard in the up position, pull the footboard support release lever and position the right footboard assembly support in front of the
wheelchair.
3. Install the hinge plates on the footboard support assembly onto the hinge pins on the wheelchair frame.
4. Push the footboard support assembly towards the inside of the wheelchair until it locks into place.
5. Repeat STEPS 2-4 for the left footboard support assembly.
6. With both footboard support assemblies locked into position, lower the footboard into the down position and ensure the footboard clips
securely hook over the left lower footboard support tube, behind the end cap.
7. If necessary, adjust the height of the footboard support assembly. Refer to One Piece Footboard Height Adjustment on page 65.
Removing
1. Lift the footboard into the up position.
2. Push the footboard support release lever inward.
3. Rotate the footboard support assembly outward.
4. Lift the footboard support assembly off of the hinge pins.
5. Repeat STEPS 2-4 for the other footboard support assembly.