Integra DTR-7.6/6.6 - Manual (Page 47)

47
Listening to the Radio
With the built-in tuner, you can enjoy AM and FM radio
stations, and store your favorite stations as presets for
easy selection.
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
■ Manual Tuning Mode
The American model changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it’s
0.05 MHz steps for FM and 9 kHz steps for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Displaying AM/FM Radio Information
Listening to AM/FM Stations
1 Use the [Tuner] input selector
button to select AM or FM.
In this example, FM has been selected.
(Actual display depends on country.)
1 Press the [Tuning Mode] button
so that the AUTO indicator
appears on the display.
2 Press the Tuning Up or Down
[
]/[ ] button.
Searching stops when a station is
found.
Tuning
Tuner
Tuning Mode
Band Frequency
AUTO TUNED
FM STEREO
1 Press the [Tuning Mode] button
so that the AUTO indicator disap-
pears from the display.
2 Press and hold the Tuning Up or
Down [
]/[ ] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
1 Press the [Display] button
repeatedly to cycle through the
available information.
1
Band, frequency,
and preset #
Listening mode