iSimple PGHSB1 - Manual (Page 10)

8
9. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction.
This warranty applies only to the original purchaser of this product from an authorized
iSimple
® dealer. This warranty covers any supplied or manufactured parts of this prod-
uct that, upon inspection by iSimple ® authorized personnel, is found to have failed in
normal use due to defects in material or workmanship. This warranty does not apply to
installation expenses. Attempting to service or modify this unit, operating this unit under
conditions other than the recommended voltage will render this WARRANTY VOID.
Unless otherwise prescribed by law, iSimple
® shall not be liable for any personal injury,
property damage and or any incidental or consequential damages of any kind (includ-
ing water damage) resulting from malfunctions, defects, misuse, improper installation or
alteration of this product. All parts of this iSimple
® product are guaranteed for a period
of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above,
iSimple
® will repair or replace the product at their discretion, if it is defective in material
or workmanship providing it is returned to an Authorized iSimple ® dealer, with PROOF
OF PURCHASE from an authorized iSimple ® dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation.
Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency
Interference Statement This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not oc-
cur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the
receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help. Notice :
The changes or modifications not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.