Image HGBE89910f - Manual (Page 6)

6
1. Before beginning, make sure that you under-
stand the information in the box above. Note:
Some parts described in the assembly steps
may be pre-assembled.
Press a 50mm Square Inner Cap (10) into each
end of the Rear Stabilizer (1).
Attach the Rear Stabilizer (1) to the indicated end
of the Bench Frame (2) with two M10 x 64mm
Carriage Bolts (16) and two M10 Nylon Locknuts
(20).
2. Press a 50mm Square Inner Cap (10) into each
end of the Front Stabilizer (3).
Attach the two Wheels (13) to the brackets on the
Front Stabilizer (3) with two M10 x 46mm Bolts
(18) and two M10 Nylon Locknuts (20).
Attach the Front Stabilizer (3) to the indicated end
of the Bench Frame (2) with two M10 x 64mm
Carriage Bolts (16) and two M10 Nylon Locknuts
(20).
1
20
20
2
1
16
10
10
2
10
13
13
18
18
2
3
20
16
10
20
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
In addition to the included allen wrench, assem-
bly requires the following tools (not included):
• Two adjustable wrenches
• One rubber mallet
• Lubricant, such as grease or petroleum jelly.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
ASSEMBLY