Image IMSB63910 User Manual

Page 9

Advertising
background image

9

5. Make sure that a qualified electrician has wired the

spa to a 240-volt power source.

Remove the two warning decals (see page 5) from
the spa shell. Using a damp cloth, wipe the spa shell
clean. Before filling the spa, make sure that it is
in the desired position and that there is room to
easily service it. Once the spa is filled, it will
have to be drained before it can be moved.

Insert a garden hose into one of the filter housings,
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level
shown at the right. Do not overfill the spa.

Refer to the inset drawing. Set the Filters (5) into the
filter housings. Next, screw the Filter Covers (3) into
the filter housings until they are fully seated.

3. Insert the pillow (47) into the lounge seat recepta-

cle. Rotate the pillow 180º to change its position.

4. The hydrotherapy spa operates on a 240-volt power source and must be wired directly to a 40 amp ground

fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified
electrician. A wiring diagram is found on the inside of the electronics pack as a reference. Under no
circumstances should the spa be wired by someone other than a qualified electrician.
Before you have
the spa wired, make sure that it is in the position you want and that it can be easily serviced, if needed.

6. Pull down one of the straps on the Spa Cover (11)

and hold the Buckle (26) against one of the premium
cedar panels on the spa. (Note: To position the
Buckle correctly, have a second person hold the
strap on the opposite side of the Spa Cover snug.)
The Spa Cover must be snug. Do not place the
Buckle over the grooves between the premium
cedar panels.
Refer to the inset drawing. Remove
the latch from the Buckle (26). Attach the Buckle to
the premium cedar panel with two #4 x 3/4” Screws
(27).

Attach the other three Buckles (26) to the premium
cedar panels in the same way.

Remove the Spa Cover (11) from the spa.

5

Fill to Here

Garden Hose

6

11

26

Strap

Strap

Latch

26

27

3

5

47

3

Advertising
This manual is related to the following products: