InFocus DH 24PD3 User Manual

Page 16

Advertising
background image

16

English

Drill bit may snap off while withdrawing the rotary hammer from the drilled

hole. For withdrawing, it is important to use a pushing motion.

Do not attempt to drill anchor holes or holes in concrete with the main unit in

the rotation only function.

Do not attempt to use the rotary hammer in the rotation and striking function

with the drill chuck and chuck adaptor attached. This would seriously shorten
the service life of every components of the machine.

6. When driving machine screws

(Fig. 18)

First, insert the bit into the socket in the
end of chuck adaptor (D).
Next, mount chuck adaptor (D) on the
main unit using procedures described
in 6 (1), (2), (3), put the tip of the bit in
the slots in the head of the screw, grasp
the main unit and tighten the screw.

CAUTION:

Exercise care not to excessively prolong driving time, otherwise, the screws

may be damaged by excessive force.

Apply the rotary hammer perpendicularly to the screw head when driving a

screw; otherwise, the screw head or bit will be damaged, or driving force will
not be fully transferred to the screw.

Do not attempt to use the rotary hammer in the rotation and striking function

with chuck adaptor (D) and bit attached.

7. When driving wood screws (Fig. 18)

(1) Selecting a suitable driver bit

Employ phillips screws, if possible, since the driver bit easily slips off the heads
of slotted-head screws.

(2) Driving in wood screws
⅜ Prior to driving in wood screws, make pilot holes suitable for them in the wooden

board. Apply the bit to the screw head grooves and gently drive the screws into
the holes.

⅜ After rotating the rotary hammer at low speed for a while until a wood screw in

partly driven into the wood, squeeze the trigger more strongly to obtain the
optimum driving force.

CAUTION:

Exercise care in preparing a pilot hole suitable for the wood screw taking the

hardness of the wood into consideration. Should the hole be excessively small
or shallow, requiring much power to drive the screw into it, the thread of the
wood screw may sometimes be damaged.

Bit

Socket

Chuck adaptor (D)

Fig. 18

Front cap

Grip

Advertising