Indesit IWSC - Manual (Page 8)

8
GB
Wash cycles
Table of wash cycles
W
ash cycles
Description of the wash cycle
Max.
temp.
(°C)
Max.
speed
(rpm)
Detergents
M
ax
.
lo
ad
(k
g)
Residual dampness
%
Energy consum- ption kWh
Total
water
lt
Cycle
duration Wash
Fabric
softener
Daily
1 White Cotton: extremely soiled whites. 90° 1200   5 53 1,57 56 130’
2 Cotton Standard 60° (1): heavily soiled whites and resistant colours. 60° 1200   5 53 0,89 44 165’
3 Cotton Standard 40° (2): lightly soiled whites and delicate colours. 40° 1200   5 53 0,80 61 160’
4 Synthetics: heavily soiled resistant colours. 50° 800   2,5 - - - 95’
4 Synthetics (3): lightly soiled resistant colours. 40° 800   2,5 44 0,47 38 90’
5 Mix Colored: lightly soiled whites and delicate colours. 40° 1200   5 53 0,59 48 80’
20° Zone
6 Cotton Standard 20°: lightly soiled whites and delicate colours. 20° 1200   5 - - - 170’
7 Mix Light 20° 800   5 - - - 120’
8 20’ Refresh 20° 800   1,5 - - - 20’
Special
9 Outwear 30° 400  - 1,5 - - - 50’
10 Wool: for wool, cashmere, etc. 40° 800   1 - - - 65’
11 Jeans 40° 800   2,5 - - - 70’
Sport
12 Sport Intensive 30° 600   2,5 - - - 85’
13 Sport Light 30° 600   2,5 - - - 60’
14 Special Shoes 30° 600  
Max. 2
pairs
- - - 55’
Partial wash cycles
Rinse
- 1200 -  5 - - - 36’
Spin + Drain - 1200 - - 5 - - - 16’
The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual
duration can vary according to factors such as water temperature and pressure, the amount of detergent used, the amount and type of load inser-
ted, load balancing and any wash options selected.
1) Test wash cycle in compliance with directive 1061/2010: set wash cycle 2 with a temperature of 60°C.
This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be
used for garments which can be washed at 60°C. The actual washing temperature may differ from the indicated value.
2) Test wash cycle in compliance with directive 1061/2010: set wash cycle 3 with a temperature of 40°C.
This cycle is designed for cotton loads with a normal soil level and is the most efficient in terms of both electricity and water consumption; it should be
used for garments which can be washed at 40°C. The actual washing temperature may differ from the indicated value.
For all Test Institutes:
3) Long wash cycle for cottons: set wash cycle 3 with a temperature of 40°C.
4) Synthetic program along: set wash cycle 4 with a temperature of 40°C.