Indesit WM 12 X - Manual (Page 13)

Mounting the wooden panel
onto the door and inserting
the machine into cabinets:
In the case where the machine
must be shipped for final
installation after the wooden
panel has been mounted, we
suggest leaving it in its original
packaging. The packaging was
designed to make it possible to
mount the wooden panel onto
the machine without removing it
completely (see figures
below).
The wooden panel that covers
the face of the machine must not
be less than 18 mm in
thickness and can be hinged on
either the right or left. For the
sake of practicality when using
the machine, we recommend
that the panel be hinged on the
same side as the door for the
machine itself - the left.
Door Mounting Accessories
(Fig. 1-2-3-4-5)
- No. 6 type A self-threading
screws, l =13 mm.
- No. 2 type B metr ic,
countersunk screws, l =25; for
fastening the magnet plate to the
cabinet.
- No. 4 type C metric screws,
l =15 mm; for mounting the hinge
supports to the cabinet.
- No. 4 type D metric screws,
l =7 mm; for mounting the hinges
on the supports.
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Fig. 5
N° 2 Hinges
N° 1 Magnet N° 1 Magnet plate
N° 1 Rubber plug
N° 2 Hinge Supports
Instructions for the fitter
A
B
C D
E
1
2
3
4
5
6
lavabiancheria
washing m
achine
machine
laver
waschm
aschine
Lato p orta
Door sid e
Cote po rte
Tur s eite
1
2
3
4
5
6
lavabiancheria
washing machine
machine
laver
waschm
aschine
Lato p orta
Door s ide
Cote p orte
Tur s eite
Fig. 4/B
N° 1 Spacer
Instructions for installation and use 12